Volvo Penta D4 Series Operator's Manual page 22

Instruments and Controls
Vessel
Settings
20
Vessel
Shows information regarding the boat's installation.
The information shown can be set under Change
gauge. Functions are also switched on and off here.
Depending on the functions installed in the boat, the
following can be displayed:
• Boat Speed
• Rudder angle
• Depth for setting echo sounder; refer to Depth
Alarm page 115.
• Fuel level
• Sea water temperature
• Freshwater level
• ACP Info for further ACP information, refer to the
ACP chapter.
Settings
Display and various system function settings are done
in the settings menu. The information shown varies
depending on the installation.
Navigate to the desired setting or function and press
to reach the sub menu.
Day/Night-Mode
Day shows dark text against a light background and
Night light text against a dark background.
Fuel Tank
Fuel tank calibration and settings. For information
regarding calibration, refer to Fuel Tank page 120.
Drive Type
The setting may only be made by authorized Volvo
Penta personnel.
Toe-In/Toe-Out Adjustment
The setting may only be made by authorized Volvo
Penta personnel.
Neutral Beep
Switches the beeper that sounds when the control is in
the neutral position on and off.
Info Beep
Switches the signal that confirms when a function has
been activated or deactivated on and off.
Info Beep level
Sets the volume (%) of the Info Beep that confirms
when a function has been activated, or deactivated.
PTA Calibration
Calibration and resetting, PTA. For information regard-
ing calibration, refer to PTA Calibration page 119.
47702599 12-2011