Volvo Penta D4 Series Operator's Manual page 34

Instruments and Controls
+
P0013214
Top mount control for twin installation
32
1
2
-
Trim Controls
The drive can be trimmed with the Power Trim panel
or with the button at the side of the control (1).
For twin engine installations, the button at the side
adjust the drives simultaneous. There is also a button
for individuall adjustments to the drives (2) on the con-
trol for twin installations.
Power Trim panel
The Power Trim panel is used for both single and twin
engine installations. For twin engine installations, the
control panel can be used to make individual or simul-
taneous adjustments to the drives.
The drive's angle and position is shown on the Power
Trim panel. By trimming out the drive away from the
transom the bow will be "raised" in relation to the hor-
izontal axis and trimming in the drive will "lower" the
bow of the boat.
Trimming out the drive
On the Power Trim panel, press button + to trim the
drive out, away from the transom. The bow will
be "raised" in relation to the horizontal axis.
Trimming in the drive
Press button – to trim the drive in, towards the transom.
The bow will be "lowered" in relation to the horizontal
axis.
47702599 12-2011