C
4
HAPTER
INSTALL THE SMARTRAX NODE
MOUNT THE SMARTRAX NODE
FIGURE 7. Node Mounting Location
1. Remove the three plugs from the back wall of the cab.
FIGURE 8. Node Mounting Bracket Installed
2. Insert three 1/4"-20 x 1" hex bolts (P/N 311-0050-105) through the holes in the node mounting bracket (P/N
107-0172-055) so that the ends of the bolts point in the opposite direction as the mounting bracket's studs.
3. Install 1/4" flat washers (P/N 313-2300-310) on the ends of the top two installed hex bolts to fill the gap
between the mounting bracket and the cab wall.
4. Secure the node mounting bracket to the back cab wall as shown in Figure 2 using three 1/4"-20 zinc flanged
lock nuts (P/N 312-4000-057).
40
SmarTrax™ Installation Manual for Kubota M7 Series
Install 1/4" Flat
Washers on