FIGURE 5. Wheel Angle Sensor Connection
6. Trace the cable coming out of the axle housing.
NOTE:
This cable is the factory wheel angle sensor (WAS) cable connection.
7. Disconnect the 6-pin WAS connection on the left side of the machine, behind the front axle.
FIGURE 6. WAS Connection Connected to Valve Harness
8. Install the remaining ends of the valve harness (P/N 115-4001-255) between the WAS connections.
9. Route the WAS cables away from moving parts and heat sources, securing them with plastic cable ties as
necessary.
016-4001-150 Rev. B
CAB COMPONENT INSTALLATION
39