Spray Shield Adjustment; Spray Boom Location; Reel Adjustment - Landoll Tilloll 875 Series Operator's Manual

OPERATION AND MAINTENANCE

Spray Shield Adjustment

1. The spray shields directly behind the disc gang have
two uses and can be adjusted accordingly.
a. The spray shield controls the flow of soil so an
even spray pattern for herbicide can be
maintained directly behind the spray shield.
b. The spray shield controls the movement of soil
by the discs. The discs are used primarily to cut
residue and level the ground for good spray
application.
2. The spray shields should be run at ground level to
level the soil.
3. The shields should also be set at an angle to carry
some soil back to the center of the machine as it
levels the soil. Set the spray shield up if the machine
is to operate deeper or there is excessive trash.
4. Set the spray shield down if the machine is to
operate at a shallower depth, or when there is a
minimum amount of trash.
5. Adjust spray shields outward on machine if too much
dirt is moving around the outer edge and leaving a
ridge. This will move dirt toward center and level the
soil.
4-6

Spray Boom Location

The spray boom for herbicide incorporation should be set
directly behind the spray shield when working in ridged
field conditions. It can also be set in front of the machine
in level field conditions.

Reel Adjustment

1. The reel is preset at the factory at the correct angle.
This angle is set to move worked soil back to the
center of the implement. The angle also determines
the incorporation ability of the reel
2. Check lock collars on reel bearings during the first
hour of use. Retighten, if necessary, as described in
step 4 on page 3-21.

When working with the reels, use care because
they rotate freely and can catch an arm, hand, or
foot and can cause severe injury.
CAUTION
F-60-0111 Edition