To Upgrade Versa Firmware; Installing The Dfu Driver; If You Are Running Windows Xp - Teledyne Tekmar Versa User Manual

failure to follow this procedure exactly can cause irreversible
damage to your equipment!

to UpGrade Versa fIrmWare

To upgrade the Versa firmware, follow the directions below:
1. Click this hyperlink: Software Downloads
(http://www.teledynetekmar.com/resources/downloads/)
2. Under Voc firmware and software, find the appropriate
firmware or software upgrade and click on it.
3. Follow the installation instructions on the next webpage.
4. Once the firmware has been obtained, click
tools | Upgrade firmware.
5. From the dropdown menu, select the board you wish to
upgrade and click browse to locate and select the new
firmware.
6. Click start.
7. Follow the instructions on the screen. Do not power down
during the flash process.
8. Unit will automatically reboot upon completion.
If the DFU driver is not installed, the upgrade will fail. In order
to install the DFU driver, you will need to follow the steps
below that pertain to the operating system on your PC.

InstallInG the dfU drIVer

If you are running Windows xp:

1. The found new hardware Wizard will begin. Choose no,
not this time, and click next.
2. Choose Install the software automatically and click next.
The Wizard will then install the new software.
3. When the install is complete click finish to close the Wizard
and reboot the Versa unit.
4. Once the Versa has rebooted, go to step 1 under To Upgrade
Versa Firmware section of this manual to upgrade the
firmware on your system.
Note: Once the firmware has been upgraded for the first time,
there is no need to reboot the unit manually during
additional firmware upgrades, unless you have changed
the USB port.
Versa User Manual
WarnInG!
Figure 4-33: Upgrade Firmware Screen
Figure 4-34: Found New Hardware Wizard
Figure 4-35: Install Software Screen
Figure 4-36: Install Complete Screen
Introduction • Page 4-14
www.teledynetekmar.com