Table of Contents
Advertisement
With the compressor switch off, disconnect the hose from the valve
15
on the tire and then pull out the power plug from the power outlet
socket.
Some sealant may leak when the hose is removed.
Install the valve cap onto the valve of the emergency repaired tire.
16
Attach the air release cap to the
17
end of the hose.
If the air release cap is not
attached, the sealant may leak
and the vehicle may get dirty.
Temporarily store the bottle in the luggage compartment while it is
18
connected to the compressor.
To spread the liquid sealant evenly within the tire, immediately drive
19
safely for about 3 miles (5 km) below 50 mph (80 km/h).
After driving, stop your vehicle
20
in a safe place on a hard, flat
surface
and
repair kit.
Remove the air release cap from
the hose before reconnecting the
hose.
8-2. Steps to take in an emergency
reconnect
the
689
8
Advertisement
Table of Contents
