Table of Contents
Advertisement
Changing settings of the pre-collision system
Enabling/disabling the pre-collision system
■
The pre-collision system can be enabled/disabled on the
screen (P. 244) of the multi-information display.
The system is automatically enabled each time the power switch is
turned to ON mode.
If the system is disabled, the
PCS warning light will turn on.
Changing the pre-collision warning timing
■
The pre-collision warning timing can be changed on the
screen (P. 244) of the multi-information display.
The operation timing setting is retained when the power switch is turned
off.
Far
1
The warning will begin to oper-
ate earlier than with the default
timing.
Middle
2
This is the default setting.
Near
3
The warning will begin to oper-
ate later than with the default
timing.
5-5. Using the driving support systems
385
5
Advertisement
Table of Contents
