Table of Contents
Advertisement
124
2-2. Charging
■
If the charging port lid does not open using the normal procedure
If the charging port lid does not open when using the normal procedure, it can
be opened in an emergency by performing the following steps.
Open the back door. (P. 285)
1
Prepare the wheel nut wrench. (P. 618)
2
Pull the knob and remove the cover
3
shown in the illustration.
Insert a wheel nut wrench as shown in the illustration.
4
Insert the end of the wheel nut
1
wrench along the cutout of the cover
installation area.
Temporarily place the L-shaped part
2
of the wheel nut wrench where it con-
tacts the deck board.
(Place the wheel nut wrench so that it
is perpendicular to the work hole.)
From the condition in step
5
wheel nut wrench upwards into the
vehicle.
Pressing the emergency release lever
inside the work hole will unlock the
charging port lid.
Press the center of the rear edge of the charging port lid to open it.
6
(P. 111)
This unlocking method is a temporary correction procedure for emergency
use only. If the problem persists, have the vehicle inspected by your Toyota
dealer immediately.
, insert the
4
Advertisement
Table of Contents
