10.3. Driver configuration
The MUSB OTG controller is used in Host and Gadget modes while EHCI is used
only in Host mode.The following section shows the configuration options for USB
and its associated class drivers.
10.3.1. USB phy selection for MUSB OTG port
Please select NOP USB transceiver for MUSB support.
10.3.2. USB controller in host mode
10.3.2.1. MUSB OTG Host Configuration
10.3.2.2. EHCI Configuration
Please select Mistral daughter card which will automatically define Port2 in PHY
mode.
186
Device Drivers --->
USB support --->
*** OTG and related infrastructure ***
[ ] GPIO based peripheral-only VBUS sensing 'transceiver'
[ ] Philips ISP1301 with OMAP OTG
[ ] TWL4030 USB Transceiver Driver
[*] NOP USB Transceiver Driver
Device Drivers --->
USB support --->
<*> Support for Host-side USB
*** Miscellaneous USB options ***
[*] USB device filesystem
[*] USB device class-devices (DEPRECATED)
*** USB Host Controller Drivers ***
<*> Inventra Highspeed Dual Role Controller (TI, ...)
*** OMAP 343x high speed USB support ***
Driver Mode (USB Host) --->
[ ] Disable DMA (always use PIO)
[ ] Use System DMA for Rx endpoints
[*] Enable debugging messages
Device Drivers --->
USB support --->
<*> Support for Host-side USB
*** Miscellaneous USB options ***
Platform Support Products
USB Driver
Driver configuration
Version 02.01.01.08