Installation - Texas Instruments OMAP35 Series User Manual

1.
2.

6.5.2. Installation

6.5.2.1. Driver built statically
If the v4l2 video driver is built statically into the kernel, it is activated during
boot-up. If frame buffer driver is built statically it gets activated during bootup.
Modular build of frame buffer is not supported.
6.5.2.2. Driver built as loadable module
If the video driver and video library has been configured to be a loadable
modules, then the driver are built as a modules with the name omap_vout.ko
and omap_voutlib.ko, which will be placed under directory drivers/media/video/
omap/ in the kernel tree.
Copy this driver files on to the target board and issue the following command
to insert the driver:
There might be some dependencies for this module on other modules, These
modules also need to be inserted before inserting V4L2 video driver.
To remove the driver, issue the following command:
Version 02.01.01.08
Open menuconfig options from kernel command prompt. Select Device
Drivers > Multimedia devices > Video capture adapaters as mentioned in
section "V4L2 video driver:"
Select "Use NTSC_M Mode" as the TV mode from the choice menu.
Figure 6.29. Select NTSC_M as TV mode: Step 6
insmod omap_vout.ko
insmod omap_voutlib.ko
Platform Support Products
Display Driver
Installation
111