Quick Start Guide - Analog Devices EVAL-AD7386FMCZ User Manual

EVAL-AD7386FMCZ

QUICK START GUIDE

The EVAL-AD7386FMCZ is powered by the
board by default. External power supplies can be applied. See
Table 1 for a description of connectors and Table 2 for the link
configuration required. Use the following steps to evaluate the
AD7386:
1. Download and install the
available on the AD7386
installation are available on the evaluation board box
internal label. Ensure that the
disconnected from the USB port of the PC while installing
the software. The PC may need a restart after installation.
2. Ensure that the link options are configured as detailed in
Table 2.
3. Connect the EVAL-SDP-CH1Z
AD7386FMCZ, as shown in Figure 2.
Figure 2. EVAL-AD7386FMCZ Evaluation Board (Left) Connected to the
User Guide
EVAL-SDP-CH1Z
ACE evaluation software,
product page. Details of this
EVAL-SDP-CH1Z board is
board to the EVAL-
4. Connect the
USB cable. If using Windows® XP, search for the
SDP-CH1Z
drivers for the
operating system.
5. Copy the ACE plugins file, Board.AD738x, and the
Chip.AD738x folder from the FTP site to the
C:\ProgramData\Analog Devices\ACE\Plugins folder.
6. Launch the
subfolder in the Analog Devices folder in the All
Programs menu.
7. Connect an input signal to the A
A B1 channel.
IN
EVAL-SDP-CH1Z
Rev. A | Page 3 of 21
EVAL-SDP-CH1Z board to the PC via the
drivers. Choose to automatically search for the
EVAL-SDP-CH1Z board if prompted by the
ACE evaluation software from the ACE
A0, A
IN
Board (Right)
UG-1615
EVAL-
A1, A B0, or
IN IN