Adjusting The Depth Limiters - pellenc SELION C21 HD Operating Instructions Manual

3. Sharpen the cutters from one side of the chain by
filing from the interior toward the exterior. Only file
by pushing.
4. Hold the mark on the file holder parallel with the mark
on the platen. Proceed in the opposite manner for
the other side.
5. If the side platen or the top platen is damaged, file
until this part is removed.
6. All the gouges must be same length.
Important
After sharpening the cutters, check the depth lim-
iters again. If the depth limiters need adjusting
again, follow the instructions on page Section 6.10,

"Adjusting the depth limiters".

6.10. ADJUSTING THE DEPTH LIMITERS
Caution
Before working on the tool, check that
the On / Off switch is in the off position
CHAINSAW SELION C21 HD
51_149277-A
29