Adjusting The Depth Limiters - pellenc SELION M12 Operating Instructions Manual

6. All the gouges must be same length.
Important
After sharpening the cutters, check the depth limiters again. To do this follow the procedure Section 6.7,

"Adjusting the depth limiters".

6.7. ADJUSTING THE DEPTH LIMITERS
Caution
Before working on the tool, check that
the On / Off switch is in the off position
«0» and disconnect the battery power
lead.
1. Check the depth limiters every 2 or 3 sharpening op-
erations.
2. Use a depth gage corresponding to the type of chain
to be sharpened. Place the depth gauge on the
gouge.
3. If the depth limiter goes beyond, file it to the level of
the depth gage using a flat file.
CHAINSAW SELION M12
51_149238-A
31