Chain Lubrication - pellenc SELION C21 HD Operating Instructions Manual

6.5. CHAIN LUBRICATION

Lubrication is carried out continuously thanks to the
PELLENC innovation of electronic oil flow management.
Check that there is always oil in the reservoir to ensure
continuous lubrication.
Filling the oil reservoir
1. Use special guide and chain oil (P/No. 85920).
2. Unscrew the oil reservoir cap (12)
3. Carefully pour the guide and chain oil into the reser-
voir.
4. Check the oil level every hour and top it up if neces-
sary.
Note
PELLENC recommends using a biodegradable
chain oil that complies with the RAL-UZ-48 stan-
dard (ref. 85920, otherwise any oil that complies
with the RAL-UZ-48 standard) Consumables sold
separately.
• The oil reservoir must be kept clean.
• Clean the cap and the filling area before removing the
cap.
• Do not allow the oil to overflow from the reservoir; wipe
off any excess oil.
Important
The oil reservoir is equipped with a strainer. If
the oil does not reach the saw head, return the tool
to your authorized distributor so that he can clean
the strainer.
Do not use the machine if the chain oil reser-
voir is empty. Over-heating is caused by the non-
respect of this instruction:
• damage the machine and may cause burns and
injury to the user.
• cause of premature wear of the guide and the
chain which may cause the breakage of the latter.
26
CHAINSAW SELION C21 HD
51_149277-A