Chain Lubrication (First Use); Filling The Chain Oil Reservoir; Forced Lubrication Cycle - pellenc SELION C21 HD Operating Instructions Manual

4.2. CHAIN LUBRICATION (FIRST USE)

4.2.1. FILLING THE CHAIN OIL RESERVOIR

Before the first use, it is essential to fill the chain oil reser-
voir with the specific chain and guide oil (Ref.: 85920).
1. Unscrew the oil reservoir cap (12)
2. Carefully pour the guide and chain oil into the reser-
voir.
3. Screw shut the oil reservoir cap (12).
4. Release the triggers when you hear the first beep.
Important
Check the oil level every hour and top it up if nec-
essary.
Note
PELLENC recommends using a biodegradable
chain oil that complies with the RAL-UZ-48 stan-
dard (ref. 85920, otherwise any oil that complies
with the RAL-UZ-48 standard) Consumables sold
separately.

4.2.2. FORCED LUBRICATION CYCLE

The forced lubrication cycle distributes the oil from the
reservoir to the different components.
1. Press the triggers and keep them held.
2. Set the battery switch to "1".
3. An automatic cycle starts which sends oil from the
reservoir to the chain guide.
• short beep every 20 seconds during the cycle.
• 3 beeps to validate the end of the cycle.
4. Release the triggers when you hear the first beep.
Note
Once all commissioning procedures have been
completed, the tool is ready for use
CHAINSAW SELION C21 HD
51_149277-A
19