Operation Using Your Remote - Rinnai Arriva 752 Operation Manual

Operation using your remote

For the remote control functions to be available, the appliance On/Off button must be in the On
position.
The remote emits an infra-
red signal. It must be aimed
at the receiver unit located
on the right side of the fire,
normal operating range is 5 m.
Some fluorescent lights may
interfere with the transmission
of the remote signal. If you
experience this problem,
changing your operating
position may help.
The remote control will
transmit information to the
fire every time a button is
pressed.
When the timers are being
set, information is transmitted
only when the 'Time Set'
button is pressed.
When the remote is not used
for a period (approx. 5 secs),
the display will default to
standby mode, displaying only
the time. To reactivate press
any button on the keypad.
Signal transmissions
Transmissions are confirmed
by a brief illumination of the
signal indicator on the remote.
The unit will also flash and
beep to confirm the settings
have been received.
Batteries
The remote uses
two x 1.5 V AAA
batteries. Never
mix old and new
batteries.
Remove the batteries if the
remote is not going to be used
for a long time. This will help
avoid damage from leaking
batteries. After batteries
are replaced the clock and
timers may need to be
reprogrammed.
10 | Arriva 752 operation guide: 12219-C 03-20
Turning on
When in standby, pressing
the Standby / On button will
start the fire and the LED will
glow red to indicate the fire is
operating.
Preset temperatures
The temperature can be
preset to:
L (low), continuous
-
combustion on low
16-26 °C in 1 °C steps,
-
fire will turn up and down
to maintain the selected
temperature
H (high), continuous
-
combustion on high
Standby / On
Stops and operates the fire.
Flame
Controls the flame picture.
Extra low
Energy saving room
temperature control.
Lock
Child lock, locks out control
to prevent tampering.
Timer 1 and 2
Sets the timer programs.
Override
Manually overrides the
current timer operation.
Time set
Sets clock and timers.
Lock
Designed as a child lock.
When pressed all remote
functions will be locked,
except Standby / On, for the
purpose of turning the fire to
standby. The remote wlll show
'Lock'. To cancel press 'Lock'
for three seconds.
Turning to standby
Press Standby/On, this will
turn off the unit and the LED
will glow green to indicate the
fire is in standby.
Adjusting the temperature
Pressing the up and down
buttons will change the preset
temperature by increments of
1 °C, the temperature will be
displayed on the remote.