Cobalt Digital Inc 9061 Product Manual page 37

Installation and Setup
9061-OM (V4.9)
Note: • If installing the 9061 in an 8310-C-BNC or 8310-BNC frame (which is
pre-equipped with a 100-BNC rear I/O module installed across the entire
backplane) or a slot already equipped with a suitable I/O module, proceed to
card installation steps below.
• If installing the 9061 in a a slot with no rear I/O module, a Rear I/O Mod-
ule is required before cabling can be connected. Refer to Installing a
Rear I/O Module (p. 2-4) for rear I/O module installation procedure.
CAUTION
If required, make certain Rear I/O Module(s) is installed before installing the
9061 into the frame slot. Damage to card and/or Rear I/O Module can occur if
module installation is attempted with card already installed in slot.
Note: Check the packaging in which the 9061 was shipped for any extra items such
as a Rear I/O Module connection label. In some cases, this label is shipped
with the card and to be installed on the Rear I/O connector bank correspond-
ing to the slot location of the card.
Install the 9061 into a frame slot as follows:
Determine the slot in which the 9061 is to be installed.
1.
Open the frame front access panel.
2.
While holding the card by the card edges, align the card such that the
3.
plastic ejector tab is on the bottom.
Align the card with the top and bottom guides of the slot in which the
4.
card is being installed.
Gradually slide the card into the slot. When resistance is noticed, gently
5.
continue pushing the card until its rear printed circuit edge terminals
engage fully into the rear I/O module mating connector.
CAUTION
If card resists fully engaging in rear I/O module mating connector, check for
alignment and proper insertion in slot tracks. Damage to card and/or rear I/O
module may occur if improper card insertion is attempted.
Verify that the card is fully engaged in rear I/O module mating connector.
6.
Close the frame front access panel.
7.
Connect the input and output cables in accordance with the appropriate
8.
diagram shown in Table 2-1, "9061 Rear I/O Modules" (p. 2-6).
Repeat steps 1 through 8 for other 9061 cards.
9.
9061 PRODUCT MANUAL
Installing the 9061 Into a Frame Slot
2-3