Control Modes; One Eventlite (Auto) - SHOWTEC EventLITE 4/10 Q4 Set 6x Manual

EventLITE 4/10 Q4 Set 6x
Important!
● Charge only with the charging case open. If it is closed, the safety switch (24) will deactivate the
charging case.
● When charging, keep the device at least 1 meter from flames or any other heat source.
● When charging, the device may heat up. This is normal and should not affect the device's lifespan or
performance.
● Avoid depleting the battery below 10 %.
● Do not charge for more than 24 hours.
● Recharge within 3 days of use.
● Press the power button (11) at the bottom of each EventLITE to off position, when storing for more
than 7 days.
● Store in an upright position.

Control Modes

There are 7 modes:

One EventLITE (Auto)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the EventLITE is not connected with a DMX cable and Wireless DMX is switched off, it functions
as a stand-alone device. See page 25 for more information about Auto mode.
Ordercode: 44061
● Auto
● Built-in programs
● Manual
● Master/Slave
● Wireless Master/Slave
● DMX512 (4CH, 6CH, 9CH)
● Wireless DMX (W-DMX)
12
Fig. 05