Puck Handset; Operating Instructions - ORTAL 40 Series Installation And Operation Manual

Puck Handset

Control Option Radio Frequency
Puck Handset
IMPORTANT: For safety/communication purposes, Puck handset must be located within 26 feet of the receiver.
NOTE: Any device that functions using the same radio frequency as the handset will be affected when handset
is in use.

Operating Instructions

Instructions for operating the Puck Handset are shown below. For more in-depth instructions regarding operation
of each control option, please refer to either the "Homeowner's Fireplace Operation Manual" or "Remote
Operation Instructions".
Turning the Fireplace On/Off
Flame Height Adjustment
74
2 x 1.5V AAA batteries
918.0 MHz
(quality alkaline recommended)
(U.S. & Canada)
ON:
• Press and hold the
sequence has begun; release button.
OFF:
• Press and hold the
INCREASE:
• To increase flame height, press and hold + button.
DECREASE:
• To decrease flame height, press and hold – button.
• Holding the – button long enough sets the fireplace to pilot flame (Standby
Mode).
Power Supply
Replace batteries after 2 years or
when low battery indicator
appears on handset display
button until two short beeps confirms the start
button.