Engineers Facilities - Teletek electronics MAG4 User Manual

English

Engineers Facilities:

To Disable Zone 1:
Press ENABLE / DISABLE button:
Press ENABLE / DISABLE button:
Press RESET:
To Enable Zone 1:
Press ENABLE / DISABLE button TWICE:
Press RESET.
To Disable Zone 2:
Press ENABLE / DISABLE button:
Press TEST / SCROLL button:
Press ENABLE / DISABLE button:
Press RESET:
Enabling and disabling of zones 3 and 4 is done in the same way as pressing TEST/
SCROLL button till reaching the desired zone and choosing consequently buttons
DISABLE / ENABLE and RESET.
To Enable Zone 2:
Press ENABLE / DISABLE button:
Press TEST / SCROLL button:
Press ENABLE / DISABLE button:
Press RESET:
To 'One Man' Test a Zone:
Press TEST / SCROLL button:
Press TEST / SCROLL button:
Continue the "One Man" Test for zones 3 and 4 by pressing TEST / SCROLL button.
You will leave automatically the Test Mode when reaching the last zone, or at any time,
by pressing RESET.
8
Zone 1 LED will flash.
DISABLE / ENABLE LED will flash.
The zone LED will become steady.
At this point the zone 1 is disabled.
Zone 1 LED will flash.
DISABLE / ENABLE LED will flash.
At this point the zone 1 is disabled.
Zone 1 LED will flash.
ENABLE / DISABLE LED will flash.
Zone 2 LED will flash.
ENABLE / DISABLE LED will flash.
Zone 2 LED will become steady.
ENABLE / DISABLE LED will flash.
At this point the zone 2 is disabled.
Zone 1 LED will flash.
ENABLE / DISABLE LED will flash.
Zone 2 LED will be steady.
ENABLE / DISABLE LED will flash.
Zone 2 LED will flash.
ENABLE / DISABLE LED will flash.
At this point zone 2 is enabled.
TEST AND ZONE yellow LED's will flash.
Zone 1 is in Test Mode.
Flashing LED will move down to zone 2.
Zone 2 is in Test Mode.
Fire Control Panel MAG 4 - User Manual