Terminating Calls; Activating Do Not Disturb; Transferring Your Phone Settings To Another Phone - 3Com VCX 2102 Telephone Manual

62 C 6: S
HAPTER TANDARD

Terminating Calls

Activating Do Not
Disturb
Transferring Your
Phone Settings to
Another Phone
F
EATURES
You can terminate a call (hang up) by replacing the handset, pressing the
Release button, or if the call is on Speaker, turning the Speaker off by
pressing the Speaker button.
When you enable Do Not Disturb, incoming calls immediately go to the
call coverage point that you set for Call Forward Busy. This feature is set
through the VCX 7000 User Interface (see
When your telephone is in Do Not Disturb mode:
An incoming call does not cause your phone to ring.
You can use the phone to dial outgoing calls.
If your phone is part of a call pickup group, no other phone in the
pickup group can retrieve a call that comes in directly to your phone.
The incoming call goes immediately to the call coverage point.
1 At any time, press the Do Not Disturb Access button on the phone
(Model 3102 and Model 2102) or press Feature + 446 (Model 3101 and
Model 2101).
Your telephone is now in Do Not Disturb mode. The display panel shows
DND and the red light is lit next to the Do not Disturb button (Model
3102 only).
2 To disable Do Not Disturb mode, repeat step 1. The DND message
disappears from the display panel and the red light goes out.
This feature enables you to use any 3Com phone in the dialing domain as
your phone with all your phone's settings.
To transfer your phone's settings to another phone:
1 Log out of your own phone by pressing Program + 5 + 6. For phones
without a Program button, press Feature 600 + 5 + 6.
2 From the phone that you want to use as yours, enter your phone number
and password:
a Press Program + 5 + 4 (or Feature 600 + 5 + 4), enter your phone
number, and then press [#].
b Press Program + 5 + 5 (or Feature 600 + 5 + 5), enter your password,
and then press [#].
Chapter 7).