Draining Water From Clutch Housing(Al); Checking And Replacing Wiper(Am) - Kioti Daedong EX35 Manual

7 EX35(C)/EX40(C)/EX45(C)/EX50(C)
-34
DRAINING WATER FROM
CLUTCH HOUSING(AL)
(1) Plug
1. There is a plug under the clutch
housing.
2. Drain the water completely and in-
stall the plug. Drain the water into a
container and dispose of it in a proper
manner for environment protection.
3. Make sure to install the plug and not
to damage the clutch severely.
IMPORTANT
If you forget to install the plug,
the clutch can be damaged. For-
eign material can enter through
the open drain hole.
H11O647A

CHECKING AND REPLACING WIPER(AM)

INSPECTION
(1) Wiper
Check the operation and wear of the
wiper blades frequently. To replace the
wiper blade, press the wiper fixing lever
to separate it and then pull it away.
To remove the wiper arm, lift the cap of
the wiper arm, remove the nut, and set
the wiper arm upright. Then, hold the
arm head and shake it left and right to
remove the wiper arm from the drive
spindle. Disconnect the washer fluid
hose and then install a new wiper arm
to its position by aligning it to the proper
angle.
H11O648A