Kioti Daedong EX35 Manual page 142

(1) Top Link
2. The draft function is activated when
the lowest or middle hole on the top
link of the 3-point hitch is used. The
lowest hole is for sensitive draft
control.
3. To keep the plowing depth shallow,
put the draft control lever to the rear
(shallow) position.
The plowing depth tends to become
deeper naturally by outer condi-
tions.
When the load increases by the in7.
crease of the plowing depth while
the draft control lever is set to the
"Shallow" position, the plowing
depth is maintained as shallow be-
cause the reaction force is trans-
ferred to the internal system via the
top link and the lifting arm is auto-
matically lifted.
4. To keep the plowing depth deep, put
the draft control lever to the front
H11O581A
(deep) position.
5. The position of the draft control le-
ver should be different based on the
condition of soil to keep the plow-
ing depth constant.
When working on a new field, it is
recommended to put the draft con-
trol lever to the proper position for
the desired plowing depth and lock
the lever with the lock bolt.
6. When using an implement which
requires no draft function, such as
a rotary tiller and mower, use the
highest hole on the top link and put
the draft control lever in any
position.
OPERATION
7. However, if the draft control lever is
pushed forward to its end, the low-
est position of the lifting arm can be
lowered a little. On the other hand,
if the lever is pulled back to its end,
the highest position of the lifting arm
can be raised a little.
! ! ! ! !
CAUTION
If the lifting arm is properly op-
erated but abnormal noise is
still heard, the hydraulic system
may be malfunctioning. In this
case, le the engine idle for an
additional 10 to 15 minutes and
then try to start the engine
again. If the problem is still
present, contact your local
KIOTI Dealer.
5
-25
5