Kioti Daedong EX35 Manual page 139

5 EX35(C)/EX40(C)/EX45(C)/EX50(C)
-22
! ! ! ! !
WARNING
When driving on a road with an
implement attached to the rear
of the tractor, the friction of the
front wheels becomes poor, re-
sulting in poor steerability. In
this case, attach a proper front
weight and drive at a low speed.
If malfunction occurs while driv-
ing on a road, stop the tractor
in a safe place and service it. If
it is not possible to move the
tractor, set a warning triangle
behind the tractor. Otherwise,
an tail gate accident may occur.
The center of gravity of the trac-
tor is higher compared to other
common vehicles, so the pos-
sibility of the roll-over accident
is very high. Be extra careful
when driving on a lateral slope,
bumpy road, road with puddles,
and narrow road. Make sure to
set the ROPS in its original po-
sition and fasten the seat belt.
! ! ! ! !
WARNING
If stopping the engine while
driving, the steering perfor-
mance can become deteriorated
due to loss of hydraulic power,
resulting in a severe accident.
Never stop the engine while
driving.
Do not release the steering
wheel to return to the straight-
ahead position after turning
while driving. The steering
wheel in this tractor is not a self-
return type. Releasing the steer-
ing wheel while driving may lead
to a massive accident.
3-POINT HITCH CONTROL
SYSTEM
(1) Position Control Lever
(A) Lowering (B) Lifting
The 3-point hitch can be controlled by
the position control lever and the draft
control lever. Generally, the lever in-
stalled on the outer side (away from
the driver) is the position control lever
while the lever installed on the inner
side (close to the driver) is the draft
control lever.
POSITION CONTROL
1. The position control lever is used
to lift or lower the lifting arm (lower
link) of the 3-point hitch.
H11O526A