7
EX35(C)/EX40(C)/EX45(C)/EX50(C)
-10
IMPORTANT
If oil level is low, do not run en-
gine.
Never add the oil over the up-
per limit.
CHECKING ENGINE OIL
LEVEL(E)
(1) Oil Inlet Plug
(2) Gauge
(A) Oil Level is Acceptable Within This Range
1. Check the engine oil daily.
2. Park the tractor on a level ground and
lower the implement.
3. If the engine was just running, wait
for approx. 5 seconds before check-
ing the oil level.
! ! ! ! !
CAUTION
To avoid personal injury:
Be sure to stop the engine be-
fore checking the oil level.
H11O607A
(1) Oil Dipstick
(A) Upper Limit
4. Pull out the oil dipstick, clean it, and
then insert it into its original position.
Then, pull it out again and check if
the fuel level is within the specified
range.
5. If the oil level is too low, add some
new oil so that the level is within the
allowable range. (Refer to "Lubrica-
tion" in the chapter "Service".)
H11O608A
(B) Lower Limit