Engine Oil And Oil Filter - Change - Fayat Dynapac CC900G Instruction Manual

3
Fig. Engine compartment, left side
1. Drain hose
2. Plug
3. Oil filter
Fig. Engine compartment, right side
4. Filler cap
2017-07-10
Maintenance - 200 / 400 / 600 / 800 h

Engine oil and oil filter - Change

Run the engine until it is warm before draining the oil.
1,
2
2
Place a receptacle that holds at least 4 liters (1 gal.)
under the drain plug (2).
Undo the oil filler cap (4) and remove the plug (2) from
4
the end of the drain hose (1); allow all the engine oil to
run out.
Remove the oil filter (3) and insert a new one.
Collect any spillage.
Fit the drain plug (2) to the end of the hose.
Fill with fresh engine oil (see under Lubricants heading
for the correct oil grade), refit the filler cap (4) and
check the level on the dipstick.
Start the engine and check the tightness around the oil
filter.
4812274432.pdf
Switch off the engine and push in the Switch off the engine and push in the
reserve/parking brake knob. reserve/parking brake knob.
Take great care when draining fluids and oils. Take great care when draining fluids and oils.
Wear protective gloves and goggles. Wear protective gloves and goggles.
Deliver the drained oil to special waste handling. Deliver the drained oil to special waste handling.
Refer to the engine manual for detailed Refer to the engine manual for detailed
instructions when changing oil and filters. instructions when changing oil and filters.
75