Safety - When Operating; Slopes - Fayat Dynapac CC900G Instruction Manual

Max 20° or 36%
Fig. Operating on slopes
2017-07-10

Safety - when operating

Prevent persons from entering or remaining in Prevent persons from entering or remaining in
the danger area, i.e. a distance of at least 7 m the danger area, i.e. a distance of at least 7 m
(23 ft) in all directions from operating machines. (23 ft) in all directions from operating machines.
The operator may allow a person to remain in The operator may allow a person to remain in
the danger area, but should then observe the danger area, but should then observe
caution and operate the machine only when the caution and operate the machine only when the
person is visible or has given clear indications person is visible or has given clear indications
of where he or she is. of where he or she is.

Slopes

This angle has been measured on a hard, flat surface
with the machine stationary.
The steering angle was zero, the vibration was
switched off and all tanks were full.
Always take into consideration that loose ground,
steering the machine, vibration on, machine speed
across the ground and raising the center of gravity can
all cause the machine to topple at smaller slope
angles than those specified here.
It is recommended that the ROPS (Roll Over It is recommended that the ROPS (Roll Over
Protective Structure) is always used when Protective Structure) is always used when
driving on slopes or unsafe ground. driving on slopes or unsafe ground.
Where possible, avoid driving across slopes. Where possible, avoid driving across slopes.
Drive instead straight up and down sloping Drive instead straight up and down sloping
ground. ground.
4812274432.pdf
Safety - when operating
5