Forward/Reverse Controls And Joints - Check And Lubrication; Hydraulic Reservoir - Check/Venting - Fayat Dynapac CC900G Instruction Manual

Figure. Forward/reverse lever
1. Friction nut
2
1
Fig. Engine compartment
1. F/R lever cable
2. Heat cover
3. Air filter
Figure. Engine compartment, right
side
1. Hydraulic fluid tank cap
2017-07-10
1
3
1
Forward/Reverse controls and joints - Check
and lubrication
Unscrew the protective plate. Check the friction on the
forward/reverse lever. The friction nut (1) should be
applied with sufficient pressure to keep the
forward/reverse lever in the set position during
operation.
If the lever gets stiff after prolonged use, lubricate the
lever at the bearing bushings and at the cable with a
few drops of oil at each place.
If the forward/reverse lever still is stiff after the above
adjustments, lubricate the other end of the control
cable with a few drops of oil. The cable is located on
the top of the propulsion pump.

Hydraulic reservoir - Check/venting

Unscrew and make sure that the reservoir cap is not
blocked. Air must have unobstructed passage through
the cap in both directions.
If blocked in either direction, clean with a little diesel oil
and blow with compressed air until unblocked or
replace the cap with a new one.
Wear eye protectors and gloves when working Wear eye protectors and gloves when working
with compressed air. with compressed air.
4812274432.pdf
Maintenance - 2000h
91