Hydraulic Fluid Filter - Change; Engine Oil And Oil Filter - Change - Fayat Dynapac CC900G Instruction Manual

Fig. Engine compartment, left side
1. Hydraulic fluid filter
3
Fig. Engine compartment, left side
1. Drain hose
2. Plug
3. Oil filter
2017-07-10

Hydraulic fluid filter - Change

Thoroughly clean the filter holder sealing surface.
1
Apply a thin coat of fresh hydraulic fluid to the rubber
gasket on the new filter.
Screw the filter on by hand, firstly until the filter gasket
makes contact with the filter base. Then rotate a
further ½ turn.
Start the engine and check that the filter does not leak.

Engine oil and oil filter - Change

Run the engine until it is warm before draining the oil.
1,
2
2
Place a receptacle that holds at least 4 liters (1 gal.)
under the drain plug (2).
4812274432.pdf
Maintenance - 2000h
Remove the filter (1) and deliver to special waste Remove the filter (1) and deliver to special waste
handling. This is a single-use filter and cannot be handling. This is a single-use filter and cannot be
cleaned. cleaned.
Do not over-tighten. The seal can be damaged. Do not over-tighten. The seal can be damaged.
Switch off the engine and push in the Switch off the engine and push in the
reserve/parking brake knob. reserve/parking brake knob.
Take great care when draining fluids and oils. Take great care when draining fluids and oils.
Wear protective gloves and goggles. Wear protective gloves and goggles.
93