Front Axle Oil Change; Transmission Oil Drain Plug - Daedong DK-Series Manual

6-8 DK65/75/80/90
CHANGE

(1) Transmission Oil Drain Plug

1. Remove the drain plug and allow the
oil to drain completely.
2. Remove the transmission case cover
and clean any debris from the magnet.
3. Clean and reinstall the case cover and
drain plug.
4. Fill with the prescribed amount and
type of transmission oil through the oil
inlet.
5. After letting the engine run for 2 to 3
minutes, you should check the oil
amount again (the oil level should be
between the upper and lower limit of
the oil gauge).
Oil capacity with
filter change
CAUTION
Do not drive the tractor after
changing the transmission oil
until it has run for 2-3 minutes;
and the correct oil level has been
verified.
628O606A

FRONT AXLE OIL CHANGE

58 (15.3 U.S.gal.)
(1) Drain Plugs
(2) Oil Level Sight Gauge
(3) Oil Fill Plug
Remove all 3 drain plugs, one from the
differential and from the left and right axle
housings; and allow the oil to drain
completely. Replace the drain plugs and
add the prescribed amount of approved
gear oil through the oil fill port. The oil
level should be between H and L on the
sight gauge. Allow a few minutes for the
oil level to stabilize and check again.
Front axle housing
oil capacity
Front differential
oil capacity
628O607A
3.5 -per side
(0.9 U.S.gal.)
4.5
(1.2 U.S.gal.)