Hydraulic Control Unit Use Reference Chart; Position & Draft Control - Daedong DK-Series Manual

5-20 DK65/75/80/90

HYDRAULIC CONTROL UNIT USE REFERENCE CHART

In order to handle the hydraulics properly, the operator must be familiar with the following. Though this information may not be
applicable to all types of implements and soil conditions, it is useful for general conditions.
I m p l e m e n t
628O501A
Soil
condition mounting holes
Light soil
Moldboard
Medium soil
plow
Heavy soil
Disc plow -
Harrow
(spike,
spring-tooth,
-
disc type)
Sub-soiler...
Earthmover,
digger,scraper,
manure fork,
cultivator,
-
rear carrier...
Mower
(mid and rear-
mount type)
Hayrake,tedder...
Box blade
with Position control
Position & Draft control
628O502A 628O503A
(1) Position control lever
Top link
(2) Draft control lever
2 Draft and Mixed control:
Place the draft control le-
2 or 3
ver to the desired position
3
to set draft sensitivity; and
2 or 3
use the position control le-
ver to establish the amount
of draft.
2 or 3
3
Position control:
Push the draft control le-
ver to the forward most
position. Use the position
1
control to set and maintain
a constant depth or height
of the implement.
3
628O504A 628O505A
Gauge Lower link
w h e e l stabilizers
Adjust the lower link stabilizer
so that the implement can move
5 ~ 6 cm (2.0 ~ 2.4 in.) laterally.
Lower link stabilizer should be
tight enough to prevent exces-
YES/NO Loose
sive implement movement
when implement is in the raised
position.
Adjust lower link stabilizer for
minimal lateral movement of the
YES/NO
implement.
Tighten
NO
R e m a r k s