Checking And Adjusting Front Axle; Toe-In Adjustment; Draining Water From The Clutch Housing - Daedong DK-Series Manual

TOE-IN ADJUSTMENT

(1) Tie Rod
(2) Lock Nut
1. Loosen the lock nuts and turn the tie
rod; adjusting the rod length until the
proper toe-in measurement is obtained.
2. Retighten the lock nuts.

CHECKING AND ADJUSTING FRONT AXLE

628O621A
(1) Nut
(2) Bolt
If loose or improperly adjusted, front axle
vibration can occur. To adjust the front
axle, loosen the nut and fully tighten the
bolt. Loosen the bolt 1/16 of a turn and
retighten the nut.

DRAINING WATER FROM THE CLUTCH HOUSING

628O622A
(1) Drain Plug
Water can accumulate in the clutch hous-
ing if submerged in water or during pres-
sure washing. Remove the drain plug from
the clutch housing every 50 hours to
drain any water from the housing.
MAINTENANCE 6-15
628O623A