How To Start In Winter; Stopping The Engine; Tractor Warming Up - Daedong DK-Series Manual

5-6 DK65/75/80/90

HOW TO START IN WINTER

1. Turn the start switch to the "ON"
position. Wait until the preheat (glow
plug) indicator light goes off (about 20
seconds).
2. Depress the clutch and continue the
normal starting procedure.
3. If the engine does not run smoothly,
shut down the engine and repeat the
preheat procedure.
4. Allow the engine to reach its normal
operating temperature before starting
work.

STOPPING THE ENGINE

1. Reduce the engine speed, depress the
clutch pedal and apply even pressure
to both brake pedals.
2. Shift the transmission into neutral and
turn off the PTO.
3. Lower any attached implements.
4. Allow the engine to idle for a short
time before turning it off. Stopping a
hot engine under load or at high speed
may damage the engine.
5. Set parking brake.
6. Turn the key switch to the OFF posi-
tion and remove the key.
IMPORTANT
Always remove the key when
leaving tractor. It prevents unau-
thorized use and ensures that all
electrical systems are turned off.
WARNING
Touching the muffler, heat shield
or exhaust after running the en-
gine will cause serious burns.
CAUTION
To avoid turbo charger damage:
Do not accelerate quickly right
after engine start.
Allow engine to idle before start-
ing work and before shutdown.

TRACTOR WARMING UP

CAUTION
To avoid personal injury:
Always keep the parking brake
set during engine warm up.
Always allow the engine to reach its
normal operating temperature before
starting work. A minimum 5 minute warm
up is required to ensure that engine oil
reaches every part of the engine. Apply-
ing a load to a cold engine will shorten its
life and may cause serious damage.