12.3.2. ∑-7W
Parameter
SIZE
No.
Output Signal
2
Selection 7
Active Mode ON Signal Mapping
Digit
Pn518
0
1
2
Refer to the SERVOPACK manuals.
3
/ACT_MOD (Active
2
Mode On ) Signal
Allocation
Allocated Pin Number
Digit
0
Pn5BF
~
2
Polarity Selection
Digit
3
Name
0
Disabled (the above signal output is not used).
Axis A: Output the signal from the CN1-1 and CN1-2 output terminals.
1
Axis B: Output the signal from the CN1-23 and CN1-24 output terminals.
Axis A: Output the signal from the CN1-25 and CN1-26 output terminals.
2
Axis B: Output the signal from the CN1-27 and CN1-28 output terminals.
3~6
Reserved settings (Do not use.)
000
Disabled (the above signal output is not used).
001
Allocate the signal to CN1-1 and CN1-2.
023
Allocate the signal to CN1-23 and CN1-24.
025
Allocate the signal to CN1-25 and CN1-26.
027
Allocate the signal to CN1-27 and CN1-28.
029
Allocate the signal to CN1-29 and CN1-30.
0
Disabled (the above signal output is not used).
1
Output the above signal.
2
Invert the above signal and output it.
Setting Range
-
-
Factory
Units
Setting
-
0000
-
0000
900-200-100
When Enabled
After resetting the
system or
recalculating
parameters
After resetting the
system or
recalculating
parameters
53/57