YASKAWA SGDV-OSA01A User Manual page 45

■Active Mode ON Signal
I/O signal allocations）
Output Signal Names
and Parameters
Active Mode ON Signal
Pn518.0
Pn512.0=1
Pn512.1=1
Note: /ACT_MOD output signal is for Axis A only.
■Active Mode ON Signal
Signal Allocations）
入出力信号コネクタ(CN1) のピン番号に割り付けられる出力信号とパラメータ設定の関係を以下に示します。
Output signal
/ACT_MOD
Relationship between Parameter Settings and Pin Numbers (/ACT_MOD)
Parameter
Pn5BF n.□000
[Factory setting]
n.□001 *
n.□023 *
n.□025 *
n.□027 *
n.□029 *
* If Pn5BF is set to n.1□□□ (Output the signal) or n.2□□□ (Invert the signal and output it) and Pn5BF is not set to any of
these values, an A.040 alarm (Parameter Setting Error) will occur.
Relationship between Parameter Settings and Polarities (/ACT_MOD)
Parameter
Pn5BF n.0□□□
[Factory setting]
n.1□□□
n.2□□□
Allocations(∑-7W SERVOPACK with 400 V-Input Power model, using
Output
Aixs A：
Signal
1 (2)
/ACT_MOD
Reverse polarity for CN1-1, CN1-2,
CN1-23, and CN1-24
Reverse polarity for CN1-25, CN1-26, CN1-27, and CN1-28
Allocations(∑-7W SERVOPACK with 400 V-Input Power model, using
Output Signal Name
Active Mode ON Signal
Description
Disable (the signal output is not used).
Allocate the signal to CN1-1, -2.
Allocate the signal to CN1-23, -24.
Allocate the signal to CN1-25, -26.
Allocate the signal to CN1-27, -28.
Allocate the signal to CN1-29, -30.
Description
Disable (the signal output is not used).
Output the signal.
Invert the signal and output it.
Cn1 Pin No.
Axis B： Axis A：
23(24) 25(26)
1
Σ-7S-compatible
Axis B：
27(28)
2
(Factory setting)
(Factory setting:
Multi-Axis Output
Parameter
Pn5BF
When Enabled Classification
After restart
When Enabled Classification
After restart
900-200-100
Disabled
(Not Used)
0
0
Polarity not
inverted)
Setup
Setup
45/57