Setup Review; Printer Continuous Output; Carriage Return/Line Feed Selection; End-Of-Print Line Feeds - Cardinal 758 Operation Manual

Printer Continuous Output

The display will now show PC=
is displayed, the feature has been enabled and the 758 will send a continuous output of weight
data to the serial I/0 connector. If a 0 (0=NO) is displayed the data will only be transmitted when
the PRINT key is pressed or on receipt of an ENQ command from a computer. Press the ZERO
key to change between 1 (YES) and 0 (NO). Once the proper setting is displayed, press the
PRINT key to save the setting. Note: This setting may be revised without having to enter the
calibration mode.

Carriage Return/Line Feed Selection

The display will now show CrLF
I/0 port (when the PRINT key is pressed) will be terminated with a carriage return and a line feed
or a carriage return only. Press the UNITS key to view the current setting. If a 1 (1=ON) is
displayed, the data will be terminated with a carriage return and a line feed. If a 0 (0=OFF) is
displayed, the data will be terminated with a carriage return only. Press the ZERO key to change
the setting between 1 (YES) and 0 (NO). Once the proper setting is displayed, press the PRINT
key to save the setting. Note: This setting may be revised without having to enter the calibration
mode.

End-Of-Print Line Feeds

The display will now show EoP=
a number of line feed commands to space the paper in the printer to the desired position for
withdrawal or for the next print. Press the UNITS key to view the current setting. If the setting
shown is acceptable, press the PRINT key to save it. Otherwise, use the ZERO and UNITS keys
to select the desired number of line feeds (0 to 99). With the desired number displayed, press
the PRINT key to save the setting. Note: This setting may be revised without having to enter the
calibration mode.
The indicator will display donE
the power from the indicator, re-install the calibration jumper J1 and re-assemble for use.
The 758 allows several operational parameters to be reviewed and changed as necessary
without having to enter the setup and calibration mode. The parameters in the setup review will
be processed in the following sequence:
To enter the setup review mode, simply turn the 758 off then press and hold the PRINT key then
press the ON key. The display will then prompt for entry of the power up zero feature PUO=
Refer to the instructions listed in the Setup and Calibration section of this manual for information
on how to change these parameters.
For a quick reference, the following chart shows a summary of the setup and calibration steps.
SETUP AND CALIBRATION, Cont.
PC=. Press the UNITS key to view the current setting. If a 1 (1=YES)
CrLF. This feature determines if the data transmitted from the serial
EoP=. At the end of a data transmission to a printer, the 758 can send
donE. The setup and calibration process has been completed. Remove

SETUP REVIEW

POWER UP ZERO
AUTOMATIC SHUTOFF TIME
SLEEP MODE TIME
BAUD RATE
PRINTER CONTINUOUS OUTPUT
CARRIAGE RETURN/LINE FEED SELECTION
END-OF-PRINT LINE FEEDS
10
PUO=.