Changing The Programming Code; Changing The Secure Code; Changing The Facility Code - Rosslare AYC-W6500 Installation And Programming Manual

Reader Functionality
If an incorrect option number is entered, the reader returns to Transmit
mode and remains unchanged.
4.3.5

Changing the Programming Code

• The programming code cannot be erased. The code 0000 is not valid and
does not delete the programming code.
• The factory default programming code is 1234.
• It is recommended to change the default programming code.
The programming code is used to enable programming the reader. The
programming code is set in Menu 3.
To change the Programming code:
1. Enter Programming mode.
2. Press 3 to enter Menu 3.
3. Enter the new code you wish to set as the programming code.
The unit sounds three beeps.
The system returns to Normal Access mode.
4.3.6

Changing the Secure Code

The default Secure code is 3838.
This code can be erased by entering the PIN code value 0000.
The Secure code is used to switch from Normal mode to Secure Access mode.
The Secure code is set in Menu 4.
To change the Secure code:
1. Enter Programming mode.
2. Press 4 to enter Menu 4.
3. Enter the new code you wish to set as the Secure code.
The unit sounds three beeps.
The system returns to Normal Access mode.
4.3.7

Changing the Facility Code

This code is used only by PIN codes that are transmitted in multiple keys
formats. It is inserted in the MSB byte of the transmitted data, one bit
following the leading parity bit.
The default Facility code is 000.
The Facility code is set in Menu 5.
To change the Facility code:
1. Enter Programming mode.
Press 5 to enter Menu 5.
2.
AYC-W6500 Installation and Programming Manual 25