Closing The Chassis - Bdcom S2518PB Hardware Installation Manual

(5)
Note:
After taking off the cover, put it horizontally and avoid it to be crushed or collided.
Otherwise, the chassis is hard to install.

4.2 Closing the Chassis

The section mainly describes how to put the cover and close the chassis. Do as follows:
(1)
(2)
(3)
(4)
When the cover is opened, put it aside. The main board of the system
appears.
Keep the cover aligned with the bottom of the chassis and move it towards
the direction of the arrow as shown in the following figure.
Nail the bolt and screw it tightly with the screwdriver.
Reinstall the switch on the DIN rail or on the desk.
Reconnect all cables of the switch.
S2518PB Hardware Installation Manual
- 15 -