Max Gain Adjustment; Picture Frame Setting - Sony DCR-IP210 Adjustment
Hide thumbs
Also See for DCR-IP210:
- Operating instructions manual (220 pages) ,
- Service manual (101 pages)
Table of Contents
Advertisement
DCR-IP210/IP210E/IP220/IP220E
10. MAX GAIN Adjustment
Setting the minimum illumination.
If it is not consistent, the image level required for taking subjects in
low illuminance will not be produced (dark).
Subject
Adjustment Page
Adjustment Address
Note1: Shoot the clear chart with the zoom WIDE end. And adjust the
direction of the camera so that the chart is located in the center of
the screen.
Note2: This adjustment should be carried out upon completion of "Flange
back Adjustment".
Note3: The data of page: 0, address: 10 must be "00".
Note4: NTSC model: DCR-IP210/IP220
PAL model: DCR- IP210E/IP220E
Switch setting:
1) POWER .................................................................. CAMERA
2) NIGHT SHOT .................................................................. OFF
3) ZOOM .................................................................... WIDE end
4) DIGITAL ZOOM (Menu display) ................................... OFF
5) STEADY SHOT (Menu display) ..................................... OFF
Adjusting method:
Order Page Address Data
1
0
01
2
6
2C
3
6
96
4
6
97
5
6
01
6
6
02
Note5: The adjustment data will be automatically input to page: F, address:
19.
Processing after Completing Adjustments
Order Page Address Data
1
6
2C
2
6
96
3
6
97
4
6
01
5
0
01
Clear chart (Approx. 1m from the
front of the lens) (Note1)
F
19
Procedure
01
Set the data.
01
Set the data.
Set the following data.
25 (NTSC), 2E (PAL)
00
Set the data.
6F
Set the data, and press PAUSE
button.
Check that the data changes to
"01". (Note5)
Procedure
00
Set the data.
00
Set the data.
00
Set the data.
00
Set the data, and press PAUSE
button.
00
Set the data.
11. Picture Frame Setting
Subject
Measurement Point
Measuring Instrument
Specified Value
Note1: The following adjustments should be carried out upon completion
of "Flange Back Adjustment".
Note2: The data of page: 0, address: 10 must be "00".
Switch setting:
1) POWER .................................................................. CAMERA
2) NIGHT SHOT .................................................................. OFF
3) DIGITAL ZOOM (Menu display) ................................... OFF
4) STEADY SHOT (Menu display) ..................................... OFF
Setting method:
1) Adjust the zoom and the camera direction, and set to the
specified position.
2) Mark the position of the picture frame on the monitor display,
and adjust the picture frame to this position in following
adjustments using "Color reproduction adjustment frame".
Check on the oscilloscope
1. Horizontal period
A=B
B
A
2. Vertical period
E
Check on the monitor TV (Underscanned mode)
Color bar chart picture frame
6-28
Color bar chart
(Color reproduction adjustment frame)
(1.5m from the front of the lens)
Video terminal of A/V jack
Oscilloscope and TV monitor
A=B, C=D, E=F
C=D
C
D
Fig. 6-1-10.
E=F
F
V
Fig. 6-1-11.
Monitor TV picture frame
Fig. 6-1-12.
Advertisement
Table of Contents
