Flange Back Adjustment (Using Flange Back Adjustment Chart And Subject More Than 500M Away); Flange Back Adjustment (1) - Sony DCR-IP210 Adjustment
Hide thumbs
Also See for DCR-IP210:
- Operating instructions manual (220 pages) ,
- Service manual (101 pages)
Table of Contents
Advertisement
DCR-IP210/IP210E/IP220/IP220E
8. Flange Back Adjustment
(Using Flange Back Adjustment Chart and Subject
More Than 500m Away)
The inner focus lens flange back adjustment is carried out
automatically. In whichever case, the focus will be deviated during
auto focusing/manual focusing.
8-1. Flange Back Adjustment (1)
Subject
Measurement Point
Measuring Instrument
Adjustment Page
Adjustment Address
Specified Value
Note1: Perform this adjustment under the condition that the zoom switch
(RV4001 of the control switch block (SS-2980)) is surely
connected.
Note2: This adjustment should be carried out upon completion of the
following adjustments.
"HALL Adjustment", "MR Adjustment"
Note3: Make the lens horizontal and perform this adjustment.
Note4: The data of page: 0, address: 10 must be "00".
Note5: Check that the data of page: 6, address: 02 is "00". If not, to page:
6, address: 01, set data: 00, and press the PAUSE button.
Switch setting:
1) POWER .................................................................. CAMERA
2) NIGHT SHOT .................................................................. OFF
3) COLOR SLOW SHUTTER ............................................. OFF
Preparations:
1) Check that at both the zoom lens TELE end and WIDE end,
the center of the chart for the flange back adjustment and center
of the exposure screen coincide.
Adjusting method:
Order Page Address Data
1
0
01
2
6
01
3
6
01
4
6
02
5
F
57
Note6: Don't touch the zoom switch, If you touch the zoom switch, the
zoom center adjustment data will be rewritten in the value that
isn't correct.
Note7: The adjustment data will be automatically input to page: F, address
11, 48 to 58.
Flange back adjustment chart
(2.0 m from the front of the protection
glass)
(Luminance: 350 ± 50 lux)
Adjustment remote commander
F
11, 48 to 58
Data of page: F, address: 57 is "00" to
"09".
Procedure
01
Set the data.
13
Set the data, and press PAUSE
button. (Note6)
15
Set the data, and press PAUSE
button.
Check that the data changes to
"01". (Note7)
Check the data is "00" to "09".
Processing after Completing Adjustments:
Order Page Address Data
1
6
01
2
6
01
3
6
01
4
0
01
5
6-26
Procedure
00
Set the data, and press PAUSE
button.
25
Set the data, and press PAUSE
button.
00
Set the data, and press PAUSE
button.
00
Set the data.
Perform "Flange Back
Adjustment (2)"
Advertisement
Table of Contents
