Max Gain Adjustment; F No. & Nd Light Quantity Standard Data Input - Sony DCR-IP5 Service Manual

8. MAX GAIN Adjustment

Setting the minimum illumination.
If it is not consistent, the image level required for taking subjects in
low illuminance will not be produced (dark).
Subject Clear chart (Color reproduction
adjustment frame) Note1
Adjustment Page F
Adjustment Address 1D
Note1: Refer to "11. Picture Frame Setting".
Switch setting:
1) POWER .................................................................. CAMERA
Adjusting method:
Order Page Address Data
1 0 01 01
2 6 96 00
3 6 97
4 6 01 6F
5 6 02
Note2: The adjustment data will be automatically input to page: F, address:
1D
Processing after Completing Adjustments:
Order Page Address Data
1 6 96 00
2 6 97 00
3 6 01 00
4 0 01 00
Procedure
Set the data.
Set the data.
Set the following data, and press
PAUSE button.
48: DCR-IP5/IP7BT (NTSC)
31: DCR-IP5E/IP7E (PAL)
Set the data, and press PAUSE
button.
Check that the data changes to
"01". (Note2)
Procedure
Set the data.
Set the data.
Set the data, and press PAUSE
button.
Set the data.
9. F No. & ND Light Quantity Standard Data Input
Compensate the unevenness of the light quantity of the iris meter
and ND filter.
Subject
Adjustment Page
Adjustment Address
Note1: Check that the data of page: 6, address: 02 is "00". If not, to page:
6, address: 01, set data: 00, and press the PAUSE button.
Switch setting:
1) POWER .................................................................. CAMERA
2) ZOOM .................................................................... WIDE end
Adjusting method:
Order Page Address Data
1
2 0 01
3 6 01
4 6 02
Note2: The adjustment data will be automatically input to page: F, address:
24 to 2D.
Processing after Completing Adjustments:
Order Page Address Data
1 6 01
2 0 01
5-21
DCR-IP5/IP5E/IP7BT/IP7E
Clear chart (All white)
(Approx. 27cm from the front of the lens)
F
24 to 2D
Procedure
Adjust the camera direction so that
the whole of the screen is white.
01 Set the data.
BB Set the data, and press PAUSE
button.
Check that the data changes to
"01". (Note2)
Procedure
00 Set the data, and press PAUSE
button.
00 Set the data.