Manual Adjustment; Bright Adjustment (Di-087 Board); Automatic Adjustment - Sony DCR-IP210 Adjustment

2. Bright Adjustment (DI-087 board)

Set the D range of the RGB decoder used to drive the LCD to the
specified value. If deviated, the LCD screen will become blackish
or saturated (whitish).
Note: Do either of the automatic adjustment or the manual adjustment.
2-1.

Automatic Adjustment

Mode Camera
Subject Arbitrary
Adjustment Page C
Adjustment Address 7E
Note: The data of page: 0, address: 10 must be "00".
Adjusting method:
Order Page Address Data
1 0 01 01
2 3 00 0D
3 3 01
4 3 00 00
5 0 01 00
Procedure
Set the data.
Set the data, and press PAUSE
button.
Check that the data is "00".
Set the data, and press PAUSE
button.
Set the data.
DCR-IP210/IP210E/IP220/IP220E
2-2.

Manual Adjustment

Mode
Subject
Measurement Point
Measuring Instrument
Adjustment Page
Adjustment Address
Specified Value
Note: The data of page: 0, address: 10 must be "00".
Adjusting method:
Order Page Address Data
1 0 01
2 C 7E
3 C 7E
4 0 01
A
Pedestal
6-39
Camera
Arbitrary
Pin ws (VG) of IC2201
Oscilloscope
C
7E
A = 7.6 ± 0.1V
Procedure
01 Set the data.
Change the data and set the
voltage (A) between the reversed
waveform pedestal and non-
reversed waveform pedestal to
the specified value.
Press PAUSE button.
00 Set the data.
Pedestal
2H
Fig. 6-1-18.