Initial Configuration Using The Cisco Cli-Manual Configuration - Cisco IAD2801 Series Installation Manual

Chapter 6 Power Up and Initial Configuration Procedures
Router>
Verify the initial configuration. See the
Step 11
verification procedures.
Initial Configuration Using the Cisco CLI—Manual Configuration
This section shows how to display a command-line interface (CLI) prompt for configuration using the
CLI, and it directs you to documentation for the CLI configuration.You can use the CLI if you see the
following messages at the end of the startup sequence:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
For help with interface and port numbering, refer to the
"Overview"
To proceed with manual configuration using the CLI, enter no when the power-up messages end:
Step 1
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2 Press Return to terminate autoinstall and continue with manual configuration:
Would you like to terminate autoinstall? [yes] Return
Several messages are displayed, ending with a line similar to the following:
...
Copyright (c) 1986-2007 by cisco Systems, Inc.
Compiled < date > < time > by < person >
Press Return to bring up the
Step 3
...
flashfs[4]: Initialization complete.
Router>
Type enable to enter privileged EXEC mode:
Step 4
Router> enable
Router#
Note
When you have finished the initial configuration, verify the initial configuration. See the
Step 5
Initial Configuration" section on page 6-8
OL-12433-01
online document.
Router>
To avoid losing work you have completed, be sure to save your configuration occasionally as you
proceed. Use the copy running-config startup-config command to save the configuration to
NVRAM.
Cisco IAD2801 Series Integrated Access Devices Hardware Installation Guide
"Verifying the Initial Configuration" section on page 6-8
"Interface Numbering"
prompt.
for verification procedures.
Configuring the Router
for
section of the
"Verifying the
6-7