FIGURE 8. ISO Bus Diagnostic Port Connection
INSTALL THE GPS RECEIVER CABLE
FIGURE 9. GPS Receiver Adapter Cable Connection
1. Locate and remove the existing cabling connecting the GPS receiver and the bulkhead connector to the roof.
2. Connect the two rectangular connectors of the cable (P/N 115-4010-105) to the GPS receiver.
3. Connect the remaining rectangular connector to the roof bulkhead connector.
IMPORTANT:
If utilizing a 600S or 700S, complete the following steps:
NOTE:
Ensure that all pin changes are made on the SC1 gray connector, NOT the HDU gray connector.
If serial 3D GPS OUT from the SC1 is NOT needed, complete these steps:
1. Identify the 600S/700S installation cable (P/N 115-0172-285), not included in kit.
2. Connect one end of the installation cable into the 600S/700.
3. Connect the other end of the installation cable into the roof bulkhead connector.
4. On the SC1 harness, remove pin #12 from the gray SC1 connector and populate it in pin #9 of the gray SC1
connector.
016-5032-145 Rev. C
CAB COMPONENT INSTALLATION
19