Viewing The Fault State Of The Power Amplifier; Clearing The Fault State Of The Power Amplifier - Codan Envoy Getting Started Manual

O
PERATING THE TRANSCEIVER
U
SING AN EXTERNAL POWER AMPLIFIER

Viewing the fault state of the power amplifier

When fault condition occurs, the power amplifier will switch to
by-pass mode to prevent permanent damage, and a pop-up message
will be shown on the connected Envoy control point to indicate the
fault condition.
NOTE:
To view a power amplifier's fault conditions:
1
1
1
NOTE:

Clearing the fault state of the power amplifier

When fault condition occurs, the power amplifier will switch to
by-pass mode to prevent permanent damage. Clearing the fault
condition will bring the power amplifiers back to active mode.
NOTE:
120
This feature is available only if the power amplifier's
control board firmware version is 2 or higher. Refer
to Checking the power amplifier's control board
firmware version on page 121
checking the power amplifier's control board
firmware version.
From the main menu, select
Status).
Press (Fault Info).
Press or to scroll through the current and historical
fault conditions.
The historical fault list will be cleared when the
Envoy transceiver is switched off or restarted.
This feature is available only if the power amplifier's
control board firmware version is 2 or higher. Refer
to Checking the power amplifier's control board
firmware version on page 121
checking the power amplifier's control board
firmware version.
E
(General), then
® T
NVOY RANSCEIVER
for instructions about
(HPA
for instructions about
G S G
ETTING TARTED UIDE