Table 3-2. X7 Router Idx 3.2 Led Descriptions - iDirect Evolution X7 Installation, Support, And Maintenance Manual

iDX Release Notes for details.
describes the front panel LED color and status information:
Label
POWER
STATUS
FAN
TEMP
RX1 and RX2
Installation, Support, and Maintenance Guide
Evolution X7 Satellite Router
Figure 3-1 on page 8

Table 3-2. X7 Router iDX 3.2 LED Descriptions

Signal Color/Type
Off
Green
Yellow
Off
1 second flashing Green Initial POST failed
Green
Red
Green
Red
Off
Green
Yellow
Red
Off
Yellow
1 second flashing Yellow Downstream carrier configured, demodulator
Green
X7 Front Panel LED Status Descriptions
shows the front panel and
Definition
Indicates power supply status and any power-
related problems
No or low power input
Valid power input detected
Problem with BUC voltage selection
Indicates basic operational state and problems
with core hardware
Powered off or going through initial Power-on Self-
test (POST)
HW operation is normal (all self-tests passed)
Fault: hardware, software, one or more self-test
failures, or configuration error
Provides fan status
All fans working
Failure of one or more fans
Indicates problems with the current operating
temperature
Router OFF or booting if STATUS LED is not Green
Normal operating temperature
Operating temperature is nearing the over-temp
or under-temp threshold
Operating temperature has exceeded the over-
temp or under-temp threshold
Provides downstream receive status, RX2 is
reserved for future use
Receiver off or not configured
Downstream carrier configured, demodulator not
yet locked
locked to downstream carrier, Network Clock
Reference (NCR) not yet locked
Downstream carrier configured, demodulator and
NCR locked to downstream carrier
Table 3-2
9