Physical And Environmental Considerations - iDirect Evolution X7 Installation, Support, And Maintenance Manual

CAUTION: The BUC power requirement must match the proper voltage (24 or 48
VDC). The BUC may sustain damage if used with the incorrect power supply.
Follow these basic guidelines when working with any electrical equipment:
• Disconnect all power and external cables before installing or removing the chassis
• Do not work alone
• Confirm power has been disconnected
• Do not perform any action that creates a potential hazard to people or makes the
equipment unsafe
• Never install equipment that appears damaged
• Examine the work area for possible hazards, such as wet floor, ungrounded power
extension cables, and missing safety grounds
B.3

Physical and Environmental Considerations

To protect the equipment and to avoid personal injury, observe the physical and
environmental considerations below when installing an X7 Router:
• Ventilation
A single-core protective vent on the back of the chassis provides pressure equalization
and allows reliable operation of the product. To protect the chassis from overheating do
not place this product in a built-in installation, such as a bookcase or enclosed rack,
unless proper ventilation is provided or the manufacturer instructions have been
followed.
• Power Sources
Operate this product only from an approved power source. If the power supply is
unknown, consult the teleport operator or local power company.
• Power Cord Protection
Route power supply cords so they will not be walked on or pinched; pay particular
attention to cords at plugs, convenience receptacles, and at the exit points.
• Overloading
Do not overload wall outlets, extension cords, or integral convenience receptacles.
• Electrical Safety
Power line operated equipment accessories connected to this unit must bear the UL,
NRTL, CE listing mark. Do not modify the safety features. If in doubt, contact qualified
service personnel.
• Heat
Do not place the X7 Router near heat sources, such as radiators, heat registers, stoves, or
other products (including amplifiers) that produce heat.
• Accessories
Do not place the chassis on any unstable rack, cart, stand, table, or bracket. Mounting of
the product must follow the manufacturer's instructions.
Installation, Support, and Maintenance Guide
Evolution X7 Satellite Router
Physical and Environmental Considerations
29