5 Maintenance
This chapter describes the required maintenance procedures for the correct functioning of
the X7 Router.
This chapter contains the following sections:
•
Section 5.1, Safety Guidelines to Observe During Servicing on page 19
•
Section 5.2, Maintaining the X7 Router on page 20
•
Section 5.3, Troubleshooting the X7 Router on page 20
•
Section 5.4, Removing and Replacing the Power Module on page 21
•
Section 5.5, Repacking the X7 Router on page 22
NOTE: Thoroughly review all the information in
attempting any of the procedures in the chapter.
5.1
Safety Guidelines to Observe During Servicing
When an X7 Router requires service, observe the safety guidelines in this section.
5.1.1
Do not attempt to service the X7 Router internal assembly. Opening and removing covers
exposes dangerous voltages and/or other hazards. There are no user serviceable parts inside.
Opening the units will void the warranty. Refer all servicing to qualified service personnel.
5.1.2
Disconnect the X7 Router from the power source and refer servicing to qualified service
personnel if any of the following conditions occur:
•
When the power supply cord or plug is damaged
•
If the X7 Router does not operate normally when following the operating instructions
(adjust only those controls that are covered by the operating instructions)
•
If the X7 Router has been dropped or if the chassis has been damaged
•
When the X7 Router exhibits a distinct change in performance
Installation, Support, and Maintenance Guide
Evolution X7 Satellite Router
Servicing
Conditions Requiring Service
Appendix B,
Safety, before
19