Table of Contents
Advertisement
10. Inspect and ensure that the copper center conductor only protrudes 1/8 inch (3.2 mm)
nominally beyond the rim of the F-connector. Trim if necessary.
CAUTION: The center conductor length must be a minimum of 1/16 inch (1.6 mm)
to a maximum of 1/8 inch (3.2 mm) protrusion beyond the rim of the F type
connector. It must be straight and cylindrical without any burrs at the end. Failure
to follow this technique could result in damage to the satellite router, BUC, LNB
connector and/or possible intermittent service.
D.2 Ethernet Port Pinouts
The Ethernet cable included in the order is typically a straight through cable typically used
for connection to a PC. The X7 Router is capable of Universal Cable Recognition or auto-MIDX
(auto-sensing) and will connect to a PC with the straight through Ethernet cable for Web iSite
use.
LAN 1 port is the recommended port to connect the Ethernet cable to the Ethernet port on
the PCrunning Web iSite.
Either crossover or straight through cables may be used with the X7 Router. It is not necessary
for the PCto auto-sense. Details of the X7 Router LAN/Ethernet port pinouts are described in
Section D.2.1
D.2.1
Table D-2
lists the pinouts for the Ethernet ports (labeled LAN 1-8) of the X7 Router and the
pinout order is shown in
Installation, Support, and Maintenance Guide
Evolution X7 Satellite Router
and
Section D.2.2
defines straight thru and crossover cables.
Ethernet Port Pinouts
Figure
D-6.
Table D-2. Ethernet Port Pinouts
RJ-45 Pin
1
2
3
6
Description
Tx+
Tx-
Rx+
Rx-
Ethernet Port Pinouts
37
Hide quick links:
Advertisement
Table of Contents
